Claim Status Register: SPF statements in this reference
Claim status stamp: defined by a scheme. The SPF test method and the label-value categories discussed here are set out by named standards or public authorities. They are not a measure of every form of sun-related harm, nor a complete account of protection outside the test.
SPF is often treated as a simple, all-purpose protection number. Its formal meaning is narrower. The International Organization for Standardization, in ISO 24444, defines an in vivo method for determining a sunscreen product's sun protection factor through the skin reddening response called erythema. The European Commission's sunscreen recommendation sets out a related framework for presenting SPF values and protection categories on labels.
The register separates what a number formally measures from claims that the number cannot carry. This matters because a high SPF figure can appear to settle questions about UVA, application amount or total skin protection when those are separate measurements or questions.
| Claim | Status | Body deciding or defining it |
|---|---|---|
| SPF is determined from an in vivo erythema test at 2 mg/cm². | Defined by a scheme | International Organization for Standardization, ISO 24444 |
| SPF is a UVB erythema measure. | Defined by a scheme | International Organization for Standardization, ISO 24444 |
| An SPF figure supplies a UVA protection value. | Unsupported | ISO 24444 measures SPF, while UVA requires a separate method |
| SPF 50 gives twice the erythema-weighted UVB filtering of SPF 25. | Unsupported | Arithmetic of the SPF ratio |
| Low, medium, high and very high are label categories for specified SPF bands. | Defined by a scheme | European Commission Recommendation 2006/647/EC |
This page concerns the measurement and presentation of an SPF claim. It does not assess products, decide which label wording is allowed, or provide use instructions.
What the SPF test actually measures
SPF stands for sun protection factor. In the ISO 24444 method, the endpoint is erythema, the visible inflammatory reddening response associated principally with UVB exposure. The test compares the ultraviolet dose needed to produce a defined minimal erythemal response on protected skin with the dose needed on unprotected skin. SPF is the ratio between those doses under the test conditions.
That definition is why SPF is commonly described as a UVB measure. It is not a direct reading of all ultraviolet radiation passing through a film, a count of minutes in sunlight, or a forecast of whether a person will burn. It is a biological test result produced under a specified protocol. The result is linked to erythema action, which weights wavelengths according to their effectiveness at producing this response.
ISO 24444 specifies an in vivo approach, meaning it is performed on human volunteers rather than inferred solely from a laboratory instrument. The protocol includes controls and a defined application amount. Those details are not incidental: changing the endpoint, the dose, the application film or the test procedure would change what the resulting number means.
The SPF figure therefore has a bounded evidential role. It supports a claim about resistance to UVB-related erythema within its method. It does not, by itself, quantify UVA protection, visible-light effects, infrared exposure, skin ageing, pigment change, DNA damage, environmental impact or suitability for a particular person. Some of those questions have their own methods; others cannot be compressed into one number.
Why SPF is not a linear scale
The apparent simplicity of SPF values encourages a mistaken reading: that SPF 50 must block twice as much relevant radiation as SPF 25, or that SPF 30 is only three-fifths as protective as SPF 50. Neither follows from the definition. SPF is a ratio of erythema-producing dose, so the useful mathematical comparison is the reciprocal of the factor.
Under the simplified ratio implied by the test, an SPF 30 permits one thirtieth of the erythema-weighted UVB dose through the tested film, while SPF 50 permits one fiftieth. Expressed as residual fractions, those are about 3.3% and 2.0% respectively. The corresponding filtered fractions are about 96.7% and 98.0%. These percentages are calculations from the SPF ratio, not separate test claims, and they refer to the erythema-weighted UVB metric used by SPF.
| Label SPF | Residual fraction in the SPF ratio | Filtered fraction in the SPF ratio | Source |
|---|---|---|---|
| 30 | 1/30, about 3.3% | 29/30, about 96.7% | Calculated from the SPF definition in ISO 24444 |
| 50 | 1/50, 2.0% | 49/50, 98.0% | Calculated from the SPF definition in ISO 24444 |
The difference is real, but the numerical labels are spaced on a ratio scale. Each step to a larger SPF reduces the remaining erythema-weighted UVB fraction, rather than adding an equal block of protection. This is why the distance between SPF 30 and SPF 50 cannot be read from the labels as a straightforward 20-point gain.
The calculation should not be extended beyond its terms. It is not a claim that every wavelength is reduced by exactly those percentages, and it says nothing about UVA. Spectral transmission depends on the formulation and must be assessed through the appropriate measurement.
Why 2 mg/cm² matters to the claim
ISO 24444 specifies application at 2 milligrams per square centimetre of skin. This is the application density at which the tested SPF is established. It provides a controlled, repeatable film for comparing the protected and unprotected test areas, not a description of the amount any individual will spread across their skin.
The unit can be unpacked without converting it into personal-use instructions. A milligram is one thousandth of a gram, and a square centimetre is an area measurement. Thus 2 mg/cm² means two milligrams of test product distributed over each square centimetre of the designated test site. Both figures come from ISO 24444.
Real application can differ from that standardised film in both amount and evenness. A thinner film contains less material per area; gaps and uneven distribution also change the optical path that ultraviolet radiation encounters. The labelled SPF cannot simply be carried over to an unspecified thinner or patchier layer. Nor is there a reliable general conversion that turns a guessed application amount into an individual's effective SPF. The relationship depends on the formulation, film formation and distribution as well as the amount.
This is a limitation of inference, not a defect hidden in the standard. A standardised dose is necessary if SPF values are to be comparable as test results. The error is to treat that controlled test condition as though it were a measurement of all later use. ISO 24444 establishes what was tested at 2 mg/cm²; it does not measure every possible application pattern.
For that reason, the SPF number should be read as a conditional laboratory result. It remains valuable within that condition, but the condition belongs to the meaning of the claim.
Why an SPF figure contains no UVA information
UVA and UVB are different wavelength regions with different measurement problems. SPF addresses the erythema endpoint used in ISO 24444 and is principally a UVB measure. A label showing only an SPF value therefore does not disclose the amount of UVA protection. This is not a small missing detail that can be recovered by assuming that a larger SPF automatically means proportionately larger UVA protection.
UVA protection needs a separate measure. The European Commission's sunscreen recommendation says that UVA protection should be at least one third of the labelled SPF value and that the critical wavelength should be 370 nanometres or more. Those criteria concern the balance and breadth of ultraviolet protection, not the SPF test alone. The figures are stated in European Commission Recommendation 2006/647/EC.
The publication's reference, UVA, UVB and broad-spectrum meaning in the UK, sets out the distinction between the two regions without treating broad spectrum as an SPF synonym. Its companion reference, Broad-spectrum protection measurement, addresses why a broad protection claim needs evidence beyond the UVB erythema result. For the particular label systems used to communicate UVA performance, see UVA star rating and PA system.
None of these separate measures alters the definition of SPF. An SPF figure may sit alongside UVA information on a label, but the two claims answer different questions. Reading the SPF number as a proxy for UVA would turn one test endpoint into another without a valid measurement bridge.
How the UK label categories are structured
The European Commission's Recommendation 2006/647/EC presents sunscreen efficacy through four protection categories and a restricted set of labelled SPF values. The categories are low, medium, high and very high. Their function is classificatory: they group stated SPF values rather than assert that protection rises in equal increments from one category to the next.
| Protection category | SPF values assigned to the category | Source |
|---|---|---|
| Low protection | SPF 6 and SPF 10 | European Commission Recommendation 2006/647/EC |
| Medium protection | SPF 15, SPF 20 and SPF 25 | European Commission Recommendation 2006/647/EC |
| High protection | SPF 30 and SPF 50 | European Commission Recommendation 2006/647/EC |
| Very high protection | SPF 50+ | European Commission Recommendation 2006/647/EC |
The same recommendation sets out the label values 6, 10, 15, 20, 25, 30, 50 and 50+. This structure explains why labels tend to use selected numbers rather than every possible test result. A category is not a second measurement and does not remove the ratio nature of SPF.
For UK readers, the important regulatory distinction is between the test result, the category framework and a wider statement about ultraviolet protection. The SPF value comes from the defined erythema test. The category places that value in a communication scheme. UVA substantiation remains separate. The UK cosmetics framework does not make the SPF figure an all-purpose proof of protection.
Limits of this reference
This reference covers the scientific meaning of an SPF number, the 2 mg/cm² test density, the non-linear implications of a ratio scale, the separation of SPF from UVA measurement, and the protection categories set out by the European Commission. It is not a product comparison, a ranking, a label-reading procedure or an assessment of whether a particular claim is compliant.
It does not cover water exposure, sweating, rubbing, reapplication, outdoor conditions, storage, expiry, particular skin conditions, children, ingredient safety or environmental claims. Those questions require different evidence and, in several cases, different test methods. The result from ISO 24444 cannot settle them merely because it appears as a familiar number on a label.
It also does not state that a given SPF value produces a fixed outcome for every user. The laboratory endpoint is erythema under standardised conditions. Individual responses, distribution of product and exposure circumstances are outside the number itself. A figure can be precise about its own test while remaining incomplete for other questions.
The decision rule worth retaining is simple: if the question is about UVB erythema protection at the ISO test dose, SPF is the relevant measure. If it is about UVA, seek the separate UVA evidence. If it is about anything beyond those tested claims, do not infer an answer from SPF alone.
Questions readers ask
Does SPF measure UVA protection?
No. SPF is determined through the erythema endpoint in the ISO 24444 in vivo method and is principally a UVB measure. UVA performance needs a separate assessment. The European Commission sunscreen recommendation sets separate UVA criteria, including a UVA protection level of at least one third of the labelled SPF.
Why is SPF 50 not twice as protective as SPF 25?
SPF is a ratio, not a linear percentage score. In the simplified SPF ratio, SPF 25 leaves one twenty-fifth of the erythema-weighted UVB dose and SPF 50 leaves one fiftieth. The remaining fraction is halved, but the filtered fraction changes from 96% to 98%.
What does the 2 mg/cm² SPF test amount mean?
ISO 24444 specifies two milligrams of product per square centimetre of test skin. That controlled density is part of what the tested SPF result means. It is not a measurement of how much every person applies, and an unspecified thinner or uneven layer cannot be assigned a reliable converted SPF.
Is SPF a measure of all sun damage?
No. SPF measures resistance to the erythema response used by the test method. It does not itself quantify UVA protection, pigment effects, visible-light effects, infrared exposure, environmental effects or the outcome for a particular individual. Each claim needs evidence suited to its own endpoint.
What do low, medium, high and very high protection mean?
They are category labels set out in European Commission Recommendation 2006/647/EC. Low covers SPF 6 and 10; medium covers 15, 20 and 25; high covers 30 and 50; very high covers 50+. The groups do not make SPF a linear scale.
Why do SPF labels use values such as 30, 50 and 50+?
European Commission Recommendation 2006/647/EC sets out a limited list of label values alongside its protection categories. This presentation scheme avoids treating every